Wood Blinds - Infrared Personal Control Settings

This entry was posted on 18th June 2010

Ready to go straight out of the box

All Controliss blinds are configured to work straight out of the box so you can start to enjoy the remote control as soon as you have installed the blind. All blinds that we deliver are factory programmed to work on channel 1 button so there is no need to alter any settings. 1. Insert 2 AAA batteries into the battery compartment on the back of the remote handset. 2. Point the remote control at the installed blind and press the channel 1 button on the handset followed by the left or right arrow button (because of the battery saving wake/sleep cycle you may need to keep the arrow button pressed for up to 3 secs). The slats of the Wood blind will now tilt.

Personal Settings

The remote control offers six channels, enabling you to operate six blinds independently (one blind on each of the six channels), or operate an unlimited number of blinds by programming multiple blinds on to the same channel. Your blind has been factory programmed to work on channel 1 button as standard but it is possible to change the channel for each blind. This can be very useful if you have more than one blind in a room and wish to operate the blinds individually. Changing the channel of individual blinds Point the remote control at the blind you wish to change the channel of. (It is important that the infra red receivers of any other blinds in the room are covered during this process to avoid accidental reprogramming). Press and hold the recessed [P] button with paper clip (or similar) for 5 secs, then press your new channel number button, followed by the left or right arrow button. Your blind is now programmed to operate on the new channel button. The up and down (ALL) buttons are used for operating all blinds in a room. When individual blind operation is required the appropriate channel number button for the blind should be pressed first, followed by the left or right arrow key. Changing the direction your blinds slats will rotate Point the remote control at the blind you wish to change the rotation of. (It is important that the infra red receivers of any other blinds in the room are covered during this process to avoid accidental reprogramming). Press the recessed [P] button with paper clip (or similar) 4 times consecutively. Your blind will now tilt in the opposite direction.

Remote Control Blind

Remote Control Guide

This Post was posted in Controliss® Blinds, Electric Blinds, Remote Control, Wooden Blinds and was tagged with Electric Blinds, Motorised Blinds, Remote Control, Wooden Blinds